: 




 A-Manufacturer Direct Injection anchorage glue (epoxy structural adhesive Class A) Red 








 Introduction 

 YD-8200 series plastic injection-type anchorage has YD-8208 rubber injection-type anchorage (fast curing type), YD-8218 rubber injection-type anchorage (vinyl-type), YD-8228 Injection anchorage glue (epoxy ) three standard models. Product-specific injection gun injection, two points can be replaced in the static mixer directly into the hole in the well-mixed within. 



 Features 

 * High strength, strong adhesion, good durability, just like embedded 

 ? No with glue, accurate measurement, the construction is simple, quick and easy 

 ? No expansion stress, while space is small, does not cause damage to the substrate, while a reinforcing effect 

 * Heat resistance, creep-free at room temperature, can withstand high temperature soldering to connect the body short 

 * Acid, anti-aging, anti-seismic performance 

 * Sensitivity to low humidity, long load stability in wet ring 

 * Excellent seismic performance, the use of convenient, safe and environmentally friendly; 

 ? Hard plastic packaging, unused plastic reusable, no waste 

 Scope 

 * Reinforced concrete members, bolts planting 

 * Steel wall bracket connection with the concrete anchor 

 * Structural reinforcement and anchorage frame 

 * Fixed installation of infrastructure and building structure, reconstruction and expansion project 

 * Steel and concrete structure of the anchor connection 

 ? Device-based fixed-fixed Viaduct barriers and guardrails 

 * Railways, highways, bridges, irrigation expansion reinforcement 

 * Billboards, pipe tunnels, elevated roads, noise barriers and the fence fixed 

 Application Advantages 


 1, to achieve high-strength steel rear bearing capacity, the effect is just like embedded steel bars; 


 2, no expansion of the stress, can be a small margin and small installation space; 


 3, excellent thixotropy, vertical job does not drip, does not sag; 


 4, the anchorage after the welding had no effect on the mechanical properties; 


 5, hard plastic packaging, unused plastic can be reused, not wasted; 


 6, construction convenient, rapid solidification and save hours of work. 

 Construction steps 


 1 hole 2 hole cleaning 3 dispensing 4 steel implants 5. Wait for curing 

 1, the drill: the depth is usually around 10 ~ 20d bar diameter, diameter greater than steel 4 ~ 8mm. 
 2, Chiang Khong: Clear concrete powder (three brush three blown). 
 3, steel handle: steel surface debris clean-up, rust.