: 





 Anchorage steps 

 Drilling: Use the hammer or drill drill, drill bit size of the reference to install the data tables, design required drilling depth should be drawing 
 Chiang Khong: The use of implant steel brush before clearing the hole, then use a blower to blow dust or air compressor, so repeated three times 
 Pre-Note: special mixing screw on the mouth, the glue gun into the anchorage, the first of four out of the mouth by a mixture of glue guns to be abandoned 
 Dispensing: the end of the mixing nozzle into the hole after dispensing, mixing slowly to the relocation of the mouth, to ensure that no bubbles or pores hole, plastic injection to fill the hole depth of 2 / 3 up 
 Anchorage / plant screw: a continuous rotation mode or implanted steel screw until contact with an overflow hole at the end of colloidal 
 Curing: steel / screw implant, initial setting time can not be shaken steel / screw, for half of the gel can be cured construction, but not applied torque, rubber curing completely before testing.